Acoustic Baffle; Removing The Air Baffle - Dell EMC PowerEdge MX7000 Installation And Service Manual

Figure 25. Installing a power supply unit
Next step
1 Connect the power cable to the corresponding PSU connector on the rear of the chassis.
NOTE: When installing or hot swapping a PSU, wait for 15 seconds for the system to recognize the PSU and determine its
status. The PSU redundancy may not occur until discovery is complete. Wait until the new PSU is discovered and enabled
before you remove any PSU. The PSU status indicator turns green to indicate that the PSU is functioning properly.

Acoustic baffle

NOTE: Ensure to install the air baffle to reduce the noise level of the enclosure.

Removing the air baffle

1 Press the release latch to detach the air baffle from the enclosure.
2 Pull the air baffle to remove it from the enclosure.
38 Installing and removing system components