Advertisement
4-Port USB Desktop Hub User Guide
Please read this user guide before installing and using your integrated desktop hub.
INTRODUCTION
The integrated 4-Port USB 2.0 Desktop Hub offers 480
Mbps high transmission rate and can connect up to three
devices, such as a digital camera, MP3 player, cell
phone or wireless mouse. With plug-and-play capability,
you can add a device without restarting your computer.
INSTALLATION
The hub installs automatically. If necessary, follow the
onscreen instructions to complete installation. Once the
default drivers are installed, the red LED status indicator
light will glow and you can connect devices to the hub.
NOTES
• To reach USB 2.0 high speed, your computer or host
adapter card must support USB 2.0. This hub is also
backwards compatible with USB 1.1.
• When using the hub with a computer that has a
version 1.1 USB interface, all of the devices attached
to the hub will run at USB 1.1 speed.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV
Please call for replacement parts or assistance:
Whalen Furniture Mfg., Inc.
technician for help.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.
This Class B digital apparatus complies with Canadian
ICES-003.
SYSTEM REQUIRMENTS
• Windows
• Pentium 233 MHz or higher
• At least 64 MB RAM
• Available USB port
• Mac OS 9 or later for USB 1.1 mode
• Mac OS X or later for USB 2.0 mode
WARNINGS
! Your hub automatically shuts off any port with a low
or excessive current.
! If USB Hub Current Limit Exceeded appears on your
screen, disconnect the affected USB device, click
Reset on the screen, and reconnect the device.
! If one of your hub ports is disabled, but USB Hub
Current Limit Exceeded does not appear:
• Disconnect and reconnect the affected device.
• If the port still does not work, disconnect the hub
and the device, and then reconnect.
! Keep your desktop hub dry; if it gets wet, wipe it dry
immediately.
! Do not modify or tamper with your desktop hub's
internal components. It may cause a malfunction and
invalidate its warranty.
! Modifications not approved by the party responsible
for compliance could void user's authority to operate
the equipment.
1-866-942-5362
Page 3
Model # SPCA-BWC
®
98SE/ME/2000/XP/Vista /7
Factory # 16015
Advertisement
