Table of Contents
Advertisement
effective if the appropriate bit to enable this command is set through the Product
Configuration File. If enabled, it will override the make/break ratios in the OEM
parameters in the Product Configuration File. The default is country-dependent. The
parameter value, if valid, is written to S28 bits 3 and 4.
Syntax
&P[<value>]
Defined Values
<value> Decimal number corresponding to the selected information.
0 Selects 39%-61% make/break ratio at 10 pulses per second. (Default.)
1 Selects 33%-67% make/break ratio at 10 pulses per second.
2 Selects 39%-61% make/break ratio at 20 pulses per second.
3 Selects 33%-67% make/break ratio at 20 pulses per second.
Result Codes
OK <value> = 0 to 3.
ERROR Otherwise.
3.2.3.11 &V - Display Current Configuration and Stored Profile
This command reports the current (active) configuration and the stored (user) profiles.
Syntax
&V
Result Code
OK
Example: (Need correct example)
AT&V
ACTIVE PROFILE:
B0 E1 L1 M1 N1 QO T V1 W0 X4 Y0 &C0 &D0 &G2 &J0 &K3 &Q5 &R1 &S0 &T4 &X0
&Y0
S00:002 S01:000 S02:043 S03:013 S04:010 S05:008 S06:002 S07:030 S08:002
S09:006
S10:014 S11:255 S12:050 S18:000 S25:005 S26:001 S36:007 S37:000 S38:020
S46:138
S48:007 S95:000
STORED PROFILE:
B0 E1 L1 M1 N1 QO T V1 W0 X4 Y0 &C0 &D0 &G2 &J0 &K3 &Q5 &R1 &S0 &T4 &X0
S00:002 S02:043 S06:002 S07:030 S08:002 S09:006 S10:014 S11:095 S12:050
S18:000
S36:007 S37:000 S40:105 S41:003 S46:138 S95:000
OK
3.2.3.12 &W - Store Current Configuration
This command saves the current (active) configuration (profile), including S-Parameters,
in Product Configuration File. The current configuration is comprised of a list of storable
parameters illustrated in the &V command. These settings are restored to the active
configuration upon receiving an Z command or at power up.
Syntax
&W
Result Code
OK
Advertisement
Table of Contents
