Table of Contents
Advertisement
4.9 Configuring Internal Modem With
Windows95/98/2000/NT
Windows 95:
1. Complete the installation referred to section 4.3.
2. Restart the computer after plugging in the modem. When Windows detects the modem, the
message "This wizard will complete the installation of: PCI Serial Controller" is displayed.
3. Click Next, then Other location, then enter the path to the drivers, then click OK.
4. Windows display "Windows found the following updated driver for this device: AOpen PCI
Modem Enumerator".
5. Click Finish and Windows displays "Please insert the disk labeled 'WIN95 installation Disk',
and then click OK.
6. Click OK and enter the path of the drivers again. Installation should then complete
automatically.
After completing the installation, you can check if the fax/modem was properly installed by using
the following procedure:
1. From My Computer, double click Control Panel.
2. Double click Modems.
3. Select Diagnostics tab.
4. Choose the COM port where the newly installed modem device is. Click More Info If the
Command and Response box displays results from ATI1 to AT+FCLA..., it indicates that your
fax/modem is set up properly.
Windows 2000:
1. Start computer after plugging in the modem. Windows will detect the modem.
2. Then the message "Welcome to the Found New Hardware Wizard" is displayed.
Click Next.
3. When Windows display "This wizard will complete the installation for this device:
PCI Simple communications controller", choose "Search for a suitable driver for
my device", then click Next.
4. When Windows display" Search for driver files for the following hardware device:
PCI Simple communications controller", choose "Specify a location", then click
Next.
5. In order to copy manufacturer' s files, click Browse.
6. Choose the correct path: D:\Drivers\Win2K\FM56-PL.( D is your CD-ROM.) Then
click OK.
7. Then the message will show the path you chose. Click Next.
8. If you want to continue installation, click Yes.
9. Windows has finished installation. Click Finish.
After completing the installation, you can check if the fax/modem was properly
installed by using the following procedure:
1. From My Computer, double click Control Panel.
2. Double click Modems.
3. Select Diagnostics tab.
4. Choose the COM port where the newly installed modem device is. Click on
More Info If the Command and Response box displays results from ATI1 to
AT+FCLA..., it indicates that your fax/modem is set up properly.
Advertisement
Table of Contents
