T - Set Tone Dial Default - AOpen FM56 Manual

* The 'star' digit (tone dialing only).
# The 'gate' digit (tone dialing only).
+
! Flash: the modem will go on-hook for a time defined by the value of S29. Country
requirements
may limit the time imposed.
@ Wait for silence: the modem will wait for at least 5 seconds of silence in the call
progress
frequency band before continuing with the next dial string parameter. If the modem does
not
detect these 5 seconds of silence before the expiration of the call abort timer (S7), the
modem will
terminate the call attempt with a NO ANSWER message. If busy detection is enabled,
the modem
may terminate the call with the BUSY result code. If answer tone arrives during
execution of this
parameter, the modem will handshake.
$ Wait for credit card dialing tone before continuing with the dial string. If the tone is not
detected
within the time specified by S7 (US models) or S6 (W-class models), the modem will
abort the
rest of the sequence, return on-hook, and generate an error message.
& Wait for credit card dialing tone before continuing with the dial string. If the tone is not
detected
within the time specified by S7 (US models) or S6 (W-class models), the modem will
abort the
rest of the sequence, return on-hook, and generate an error message.
, Dial pause: the modem will pause for a time specified by S8 before dialing the digits
following ",".
; Return to command state. Added to the end of a dial string. This causes the modem to
return to
the command state after it processes the portion of the dial string preceding the ";". This
allows
the user to issue additional commands while remaining off-hook. The additional
commands may
be placed in the original command line following the ";" and/or may be entered on
subsequent
command lines. The modem will enter call progress only after an additional dial
command is
issued without the ";" terminator. Use "H" to abort the dial in progress, and go back
on-hook.
^ Toggles calling tone enable/disable: applicable to current dial attempt only.
( ) Ignored: may be used to format the dial string.
- Ignored: may be used to format the dial string.
<space> Ignored: may be used to format the dial string.

3.2.3.2 T - Set Tone Dial Default

This command forces DTMF dialing until the next P dial modifier or P command is
received. The modem will set an S-Parameter bit to indicate that all subsequent dialing
should be conducted in tone mode. Note that the DP command will override this
command. Clears S14 bit 5.
This command may not be permitted in some countries. (See P.)