Table of Contents
Advertisement
Syntax
+VDT=<enable>,<report>
Defined Values
<enable> Decimal number corresponding to the selected option.
0 The modem will not produce any control tone cadence report.
1 The modem will produce control tone cadence report as specified for the <report>
subparameter.
<report> Decimal number specifying the produced any control tone cadence report when
enabled by the
<enable> subparameter.
0 The modem will produce only CPOF and CPON messages.
Other Reserved.
Reporting Current or Selected Values
Command: +VDT?
Response: +VDT: <enable>,<report>
Example: +VDT: 0,0 For the default setting.
Reporting Supported Range of Parameter Values
Command: +VDT=?
Response: +VDT: (<enable> range),(<report> range)
Example: +VDT: (0,1),(0)
Result Codes
OK <enable>,<report> = (0,1),(0)
ERROR Otherwise.
5.2.2.16 +VBT - Buffer Threshold Setting
This command causes the modem to report the <deassert> and <assert> subparameter
values as a <compound ranges of
values>. The OK result code follows the report.
Syntax
+VBT=<deassert>,<assert>
Defined Values
To be added
Reporting Current or Selected Values
Command: +VBT?
Response: +VBT: <deassert>,<assert>
Example: +VBT: TBD For the default setting.
Reporting Supported Range of Parameter Values
Command: +VBT=?
Response: +VBT: (<deassert> range), (assert>range)
Example: +VBT: (820-4096),(6144-7372), 8192
Result Codes
OK <deassert>,<assert>= 0 or 1.
ERROR Otherwise.
5.2.2.17 +VPR - Select DTE/Modem Interface Rate (Turn Off Autobaud)
To be added.
Syntax
+VPR=<rate>
Defined Values
<rate>> To be added.
Reporting Current or Selected Values
Command: +VPR?
Advertisement
Table of Contents
