Table of Contents
Advertisement
3.2.1 Generic Modem Control
3.2.1 Generic Modem Control
3.2.1.1 Z - Reset to Default Configuration
This command instructs the modem to reset to default values as altered by non-volatile
parameter storage. If the modem is connected to the line, it will be disconnected from
the line, terminating any call in progress. All of the functions of the command are
completed before the modem issues the result code. The DTE should not include
additional commands on the same command line after the Z command because such
commands are ignored.
Syntax
Z
Result Code
OK
3.2.1.2 +FCLASS - Select Active Service Class
This command selects the active service class (mode).
Syntax
+FCLASS=<mode>
Defined Values
<mode> Decimal number which corresponds to the selected service class.
Command options:
0 Select Data Mode (see Section 3). (Default.)
1 or 1.0 Select Facsimile Class 1.0 Mode (see Section 4)
8 Select Voice Mode (see Section 5)
80 Select VoiceView Mode (see Section 5)
Result Codes
OK For <mode> = 0, 1, 1.0, 8, and 80 as supported by the Product Configuration File.
ERROR Otherwise.
Reporting Current or Selected Values
Command: +FCLASS?
Response: +FCLASS: <mode>
Example: +FCLASS: 0 For the default setting.
Reporting Supported Range of Parameter Values
Command: +FCLASS=?
Response: +FCLASS: (<mode> range)
Example: +FCLASS: (0, 1,1.0,8, 80)
3.2.1.3 &F - Set to Factory-Defined Configuration
This command instructs the modem to set all parameters to factory default values
defined in the product Configuration Table
The modem loads the factory default configuration (profile). The factory defaults are
identified for each command and in the
S-Parameter descriptions. A configuration (profile) consists of a subset of S-Parameters.
Syntax
&F
Result Code
OK
3.2.1.4 I - Request Identification Information
his command causes the modem to report one or more lines of product information text
T
Advertisement
Table of Contents
