H - Enable/Disable Video Ready Mode - AOpen FM56 Manual

Response: +ILRR: (<value> range)
Example: +ILRR: (0,1)
Reported Rate
The <rate> reported represents the current (negotiated or renegotiated) DTE-modem
rate. If enabled, the intermediate result code is transmitted after any modulation, error
control or data compression reports are transmitted, and before any final result code
(e.g., CONNECT) is transmitted. The <rate> is applied after the final result code is
transmitted.
The DTE-modem port rate will change only if neither buffered mode nor error controlled
means are enabled (+ES=x,0) and if the negotiated carrier rate (+MRR) does not match
the current DTE-modem port rate (autodetected from the previous command line).
Syntax
+ILRR: <rate>[,<rx_rate>]
Defined Values
<rate> Decimal value representing the current (negotiated or renegotiated) DTE-modem
rate:
0, 300, 1200, 2400, 4800, 9600, 19200, 38400, 57600, or 115200
<rx_rate> Optional decimal value reporting the RXD rate, if it is different from the TXD
rate:
0, 300, 1200, 2400, 4800, 9600, 19200, 38400, 57600, or 115200
Example
+ILRR: 19200

3.2.2.9 +H - Enable/Disable Video Ready Mode

This command enables or disables Rockwell Video Ready Mode.
Syntax
+H[<value>]
Defined Values
<value> Decimal number corresponding to the selected option.
0 Disable video ready mode.
16 Enable video ready mode.
Result Codes
OK <value> = 0 or 16.
ERROR Otherwise.