Function And Operation; Setting The Display Parameters - Vaillant electronicVED plus Operating And Installation Instructions

3 Function and operation

3 Function and operation
If you turn on the hot water at a draw-off point (mixer or
separate tap), your electronicVED plus will automatically
heat up the drinking water.
a
Danger!
Risk of being scalded by hot water.
The water temperature at the draw-off points
can reach up to 60 °C.
> When using an electronicVED plus electric
instantaneous water heater, be aware of
the risk of scalding from high outlet tem-
peratures.
> Set your electronicVED plus to a maximum
of 43 °C if you want to be protected from
scalding.
> Section 3.1.7 "Setting the maximum temper-
ature" contains all relevant information on
the "scald protection" function, which can
be configured on your electronicVED plus.
38,5
- -
2
Fig. 3.1 Display
> Press the +
button (1) until the desired temperature is
reached. The hot water that you can now take from
the draw-off point will be at the desired temperature.
> If the temperature is too high, press the — button (2).
The water drawn will be cooler.
> Choose a temperature of between 20 °C and 60 °C to
see what suits you best.
i
All important display set-up options for
your electronicVED plus are described in
section 3.1.
6
°C
+
+
Memo eco
1
Operating instructions for the electronicVED plus electric instantaneous water heater 0020149585_00
i
Your electronicVED plus controls the water
temperature but not the volume you take
from the draw-off point. Therefore, the
desired temperature may not be reached
when drawing large volumes, especially in
cold weather. If this occurs, briefly reduce the
water volume being drawn. The water temper-
ature will increase very quickly.
3.1

Setting the display parameters

i
The electronicVED plus display can be, but
does not have to be, set up before checking
the function. It is sensible to first only set the
desired hot water temperature.
The current performance features of the electronicVED
plus are displayed as soon as the unit is connected and
configured. When in operation, the display shows the
selected water temperature. Furthermore, the maximum
water temperature that can be set will be displayed on
the uppermost display line. This maximum temperature
can be set freely and can be between 30 °C and 60 °C.
The following display is an example of this.
max. 42 °C
42.0 °C
- +

The set target temperature is factory-set to 42 °C.
The setting and display options for your VED display are
described in the following excerpts in the order that they
appear in the menus.
To access the current temperature setting quickly, you
always have two options:
> Set the current hot water temperature directly by
+
using the /— buttons.
or
> Set the current hot water temperature using the
MEMO
button.
MEMO eco
 