Fitting The Unit Cladding; Setting The Display Parameters - Vaillant electronicVED plus Operating And Installation Instructions

5 Starting up/decommissioning
5.2

Fitting the unit cladding

3
Fig. 5.2 Fitting the unit cladding
> Plug the display cable into slot X7 of the unit's elec-
tronics, as illustrated in Figure 5.1, position (2).
> Put the unit cladding (3) on.
> Tighten both bolts (2).
> Grip the panel (1) using the two straps.
> Splay the two straps (slightly pull the panel apart).
> Put the panel (1) on.
> Make sure that the hot water draw-off valve is closed.
> Connect the unit to the electrical mains (switch on the
fuse).
14
1
2
Installation instructions for the electronicVED plus electric instantaneous water heater 0020149585_00
5.3

Setting the display parameters

i
The electronicVED plus display can be, but
does not have to be, set up before checking
the function. It is sensible to first only set the
desired hot water temperature.
The current performance features of the electronicVED
plus are displayed as soon as the unit is connected and
configured. When in operation, the display shows the
desired water temperature. Furthermore, the maximum
water temperature that your VED provides will be dis-
played on the top display line. This maximum flow tem-
perature can be set freely and can be between 30 °C and
60 °C. The following display is an example of this.
max. 42 °C
42.0 °C
- +

The set target temperature is factory-set to 42 °C.
To access the current temperature setting quickly, you
always have two options:
> Set the current hot water temperature directly by
+
using the /— buttons.
or
> Set the current hot water temperature using the
MEMO
button.
i
The settings for the installer menu on the
electronicVED plus display are described
below. You can find a detailed description of
all the display functions in the instructions for
use included in this document.
MEMO eco
 