Adjusting The Seat Angle - Invacare Fox User Manual

Invacare® Fox™
1. On both sides, loosen the bottom backrest screw A.
Do not remove the screws!
2. Move the backrest to the required seat depth.
You can adjust the seat depth steplessly. Use scale B
on the seat as a guide for this purpose.
Ensure that the same seat depth is set on both sides.
3. Re-tighten the screws.

5.7 Adjusting the seat angle

CAUTION!
Adjusting the seat tilt or the backrest angle
changes the geometry of the mobility device
and directly influences its dynamic stability!
– For details regarding dynamic stability,
negotiating gradients and obstacles and the
correct adjustment of seat tilt or backrest angle,
refer to 6.5 Taking Obstacles, page 58 and 6.6
Driving up and down gradients, page 60.
40
• 10 mm open-ended spanner
• 5 mm Allen key
The possible seat angles are marked on a scale on the
center post. Depending on the rear seat height, you need to
use the bottom or top scale respectively:
• Upper seat height: use the bottom scale
• Lower seat height: use the top scale
1.
Remove the screw and nut A.
2. Adjust the center post to the desired seat angle.
3. Refit the screw and nut.
1577074-F