Table of Contents
Advertisement
Each installation site for any unit presents its own unique combustion environment. Specific factors such as
weather, wind currents, yard debris, altitude, drafts, the size of the surrounding area, all have an influence on
the proper operation of the unit. A normally operating unit will demonstrate the following characteristics:
•
A lively, realistic yellow flame
•
Odor-free
If the flame is not clean (identifiable by excessive sooting on the decorative media), refer to the information
below. Some soot on the media may occur and should not be a concern unless excessive.
•
Cover your unit whenever it is not in use, and follow the guidelines below at least annually.
ANNUAL CLEAN /INSPECTION GUIDELINES
The unit and the installation must be inspected annually. Refer to these instructions for details. Performing these
procedures will ensure proper operation, appearance, and safety. WEAR GLOVES.
If maintenance is required, it must be done by a qualified professional service technician.
•
Always shut off the gas to the unit while performing service work.
•
Allow the unit to cool before servicing.
•
The entire burner system should be inspected regularly:
Excessive debris can build up on this unit from leaves, dirt, or other debris. It is critical that all control
components, burners, vent openings, and the surrounding area be kept clean and free of all obstructions.
Examine that all components are properly assembled and installed as instructed in this manual.
Ensure that all decorative media is properly placed as instructed in this manual.
•
The burner assembly must be replaced prior to the unit being put into operation if it is evident that the
burner is damaged. Contact your local dealer for replacement parts.
•
DO NOT use substitute materials when replacing any components of the appliance.
•
Keep the vent openings and surrounding area of the of the unit clean and free of obstructions at all times.
•
Periodically perform visual checks of the burner flames. The burner flames should be blue at the base and
yellow at the body and tips. Contact a qualified professional service technician for maintenance.
•
To maintain the concrete components, first wash them with a mild soap and water solution. A vinyl brush is
recommended. Allow to dry and follow up with a concrete sealer in order to preserve the finish.
•
Any guard or other protective device removed for servicing the appliance shall be replaced prior to
operating the appliance.
•
Verify proper operation after servicing.
HOT DURING OPERATION AND AFTER USE. Children must be supervised when in the vicinity of
this appliance. Serious injury may occur! Children must be alerted to the hazard of high surface
temperatures and should stay away to avoid burns or clothing ignition.
SERVICING AND CLEANING
(Your model and design may vary)
Keep surrounding area
and vent openings
clear for proper venting
CAUTION:
11
Advertisement
Table of Contents
