Lighting Instructions - Control Knob Models; To Shut Off Gas To The Appliance - HomComfort HCGV1 Installation And Operating Manual

LIGHTING INSTRUCTIONS - CONTROL KNOB MODELS

IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT, CAUSING
A. BEFORE LIGHTING, smell all around the unit area for gas. Be sure to smell next to the floor, because some gas
is heavier than air and will settle on the floor.
B. WHAT TO DO IF YOU SMELL GAS
1. Shut off the gas to the appliance.
2. Extinguish any open flame.
3. If odor continues, immediately call your gas supplier or the fire department.
C. Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn
by hand, DO NOT try to repair it. Call a qualified professional service technician. Force or attempted repair
may result in fire or explosion.
1. STOP! Read the safety information above.
2. Ensure the gas control knob is in the OFF position before beginning lighting sequence.
3. Lay a lighted long-stem match on the surface of the decorative media near the burner (do not hold the
match in your hand) or use a lighted long-necked butane lighter.
4. Once the match is burning and in position, depress the gas control knob and turn it counter-clockwise to
the HI LIGHT position. Your burner should light.
CAUTION:
If the burner does not light before the match goes out, immediately turn the control knob
clockwise to the OFF position.
Wait approximately five (5) minutes to clear out any gas, and repeat steps 1-4 above.
If your burner fails to light again, turn the control knob clockwise to the OFF position and contact your dealer or
gas supplier.

TO SHUT OFF GAS TO THE APPLIANCE

To extinguish your gas burner, depress the gas control knob and turn it clockwise to the OFF position. Be sure the
control knob is turned fully off to avoid any gas leakage.
10
PROPERTY DAMAGE, PERSONAL INJURY, OR LOSS OF LIFE.
FOR YOUR SAFETY, READ BEFORE LIGHTING
WARNING:
OFF