Page 1
Stainless Steel Patio Heater Model: HCPHPRSS Conforms to ANSI STD Z83.26a-2008 Certified to CSA STD 2.37a-2008 IMPORTANT: Read this manual carefully before assembling, using or servicing this heater. Keep this manual for future reference. United States Stove Company 227 Industrial Park Rd South Pittsburg, TN 37380 www.usstove.com (800) 750-2723...
General Safety Information • This manual contains important information about the assembly, operation and maintenance of this patio heater. General safety information is presented in these first few pages and is also located throughout the manual. • Keep this manual for future reference and to educate new users of th is product. This manual should be read in conjunction with the labeling on the product.
Page 3
Precautions WARNING: We cannot foresee every use which may WARNING: be made of our heaters. Check with your local fire EXPLOSION· FIRE HAZARD safety authority if you have questions about heater • Never store propane near high heat, open flames, use.
Assembly Instructions COMPONENTS HARDWARE • Remove all components from package. Description Picture Qty. ADDITIONAL REQUIREMENTS The following items are not included, but are Large Bolt necessary for the proper assembly of your heater, Small Nuts DO NOT attempt to assemble without proper tools. •...
Page 5
Step 1 Optional ground fixtures (not available with all models) Attach Wheel Assembly to Base Mount optional ground fixtures with 6 pcs M6 small • Line up holes in Wheel Bracket with corresponding bolts and M6 flange nuts into holes on base housing. holes in base, insert 2 large bolts through holes and Step 3 finger tighten 2 Large Nuts.
Page 6
• Adjust the height of the tabletop. Loosen t e plastic Step 7 nut and adjust the tabletop to the height you want. Install Reflector Tighten the plastic nut. WARNING: Remove protective cover before assembly. Step 5 Attach Reflector Studs to Screen Cover Note: Leave all screws and nuts loose until entire shield •...
Step 8 marked in accordance with the specifications Attach Reflector Assembly to Studs for LP gas cylinders of the U.S. Department of • Support Heater. Transportation (DOT}. • Slide 3 large flat washers over threaded end of studs. • Never connect an unregulated propane cylinder to the heater.
Operation DANGER Caution: Do not attempt to operate until you have CARBON MONOXIDE HAZARD read & understand all General Safety Information For outdoor use only. Never use inside house, or in this manual and all assembly is complete & leak other unventilated or enclosed areas.
• If for some reason your igniter fails to deliver a should be blue with straight yellow tops. If excessive spark, your heater can be started by inserting a lit yellow flame is detected, tum off heater and consult match through the pilot view hole while pushing the “Troubleshooting”...
Maintenance If the gas control is submerged in water, DO NOT WARNING use it. It must be replaced. FOR YOUR SAFETY Air flow must be unobstructed. Keep controls, burner, DO NOT touch or move the heater for at least 45 and circulating air passageways clean.
Service Record It is recommended that this unit is serviced regularly and that the appropriate Service Interval Record is completed. Service Provider: Before completing the appropriate Service Record below, please ensure you have carried out the service as described in the manufacturer’s instructions.
Page 12
Distributed By: United States Stove Company www.usstove.com 227 Industrial Park Rd (800) 750-2723 South Pittsburg, TN 37380 1 year limited warranty - Customers in the Continental US All components are warranted for a period of 1 year after date of purchase by the original owner against defects in materials and workmanship under normal use.
Need help?
Do you have a question about the HCPHPRSS and is the answer not in the manual?
Questions and answers