Read and understand these instructions BEFORE attempting to install this product.
Failure to follow installation instructions and not using the provided hardware may
damage the intake tube, throttle body and engine.
1. Preparing Vehicle
a. Make sure vehicle is parked on level surface.
b. Set parking brake.
c. If engine has run in the past two hours, let it cool down.
d. Disconnect negative battery terminal.
e. Do not discard stock components after removal of the factory system.
2. Removal of stock system
a. Loosen hose clamps and disconnect crankcase
breather hose. Remove the intake tubing.
c. Remove the 3 bolts holding down the air box.
b. Remove plastic clip from resonator and remove
resonator.
Inlet Air Temperature Sensor (IAT)
d. Unplug the IAT from the factory air box. Remove
the air box.
3