Advertisement
INSTALLATION INSTRUCTIONS
2005-2009
2006-2009
* NOTE: Legal in California only for racing vehicles which may never be used upon a highway
AEM Induction Systems
Equipped with AEM
No Oil Required!
PART NUMBER: 21-704
JEEP
Grand Cherokee
JEEP
Commander
1 (800) 992-3000
®
Dryflow™ Filter
V8-4.7L SEE * NOTE
V8-4.7L SEE * NOTE
WWW: http://www.aemintakes.com
Advertisement
Table of Contents
Related Manuals for AEM 21-704
Summary of Contents for AEM 21-704
-
Page 1: Installation Instructions
® Equipped with AEM Dryflow™ Filter No Oil Required! INSTALLATION INSTRUCTIONS PART NUMBER: 21-704 2005-2009 JEEP Grand Cherokee V8-4.7L SEE * NOTE 2006-2009 JEEP Commander V8-4.7L SEE * NOTE * NOTE: Legal in California only for racing vehicles which may never be used upon a highway... -
Page 2: Parts List
PARTS LIST Description Qty. Part Number Hose Clamp #48 08601 Hose, Adapter 3.25/3.00 X 2.25” 5-323 Tube 2-1467 Grommet; 1”OD,1/2”ID,1/2” Thk. 08064 Hose; 1/2” ID X 7” L 08159 Bracket; Mild Stl. TB/PC 010109 Washer; 1/4”ID X 5/8”OD - SAE 08275 Washer;... - Page 3 Read and understand these instructions BEFORE attempting to install this product. Failure to follow installation instructions and not using the provided hardware may damage the intake tube, throttle body and engine. 1. Preparing Vehicle a. Make sure vehicle is parked on level surface. b.
-
Page 4: Intake System
Lift the lower airbox and remove it from the vehicle as shown. ® 3. Installation of AEM Intake System a. When installing the intake system, do not completely tighten the hose clamps or mounting hardware until instructed to do so. - Page 5 d. Install the bracket/rubber mounted stud assembly e. Install the twist bracket onto the heat shield as onto the heat shield as shown using the provided shown using the provided hardware. hardware. f. Remove the bolt that secures the vacuum reservoir to g.
- Page 6 j. Install the 6mm male/male rubber mounted stud onto k. Install the heat shield assembly into the vehicle and the upper airbox mount as shown. secure it to the mounting locations with the provided hardware. l. Reconnect the vacuum reservoir vacuum line. m.
- Page 7 3q. shown. ® t. Install the supplied rubber grommet into the AEM u. Remove the rubber sealing “O” ring from the air tem- intake tube as shown. perature sensor as shown.
- Page 8 Remove the factory crankcase vent hose from the y. Install the supplied silicone hose onto the crankcase ® “T” fitting shown. vent “T” and connect the other end onto the AEM intake tube as shown.
- Page 9 ® ® ® ab. Install the silicone hose (5-353) onto the AEM ac. Install the AEM air filter assembly onto the AEM air filter assembly and secure with the provided hose intake tube as shown and secure with the provided clamp.
-
Page 10: Service And Maintenance
® warrants that its intake systems will last for the life of your vehicle. AEM will not honor this warranty due to mechani- cal damage (i.e. improper installation or fitment), damage from misuse, accidents or flying debris. AEM will not warrant its powder coating if the finish has been cleaned with a hydrocarbon-based solvent.
Need help?
Do you have a question about the 21-704 and is the answer not in the manual?
Questions and answers