Advertisement
Quick Links
INSTALLATION INSTRUCTIONS
PART NUMBER:
2013
*NOTE: Legal in California only for racing vehicles which may never be used upon a highway
AEM Induction Systems
Equipped with AEM
No Oil Required!
Hyundai Veloster Turbo
1 (800) 992-3000
Dryflow™ Filter
®
21-724
1.6L
WWW: http://www.aemintakes.com
SEE *NOTE
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for AEM 21-724
Summary of Contents for AEM 21-724
-
Page 1: Installation Instructions
Equipped with AEM Dryflow™ Filter ® No Oil Required! INSTALLATION INSTRUCTIONS PART NUMBER: 21-724 2013 Hyundai Veloster Turbo 1.6L SEE *NOTE *NOTE: Legal in California only for racing vehicles which may never be used upon a highway AEM Induction Systems 1 (800) 992-3000 WWW: http://www.aemintakes.com... - Page 2 ITEM NO. PART NUMBER DESCRIPTION QTY. 2-1498 UPPER TUBE, 2013 HYUNDAI VELOSTER TURBO 5-275 HOSE, SILICONE 2.75X3” BLK 9444 HOSE CLAMP, 2.31-3.25” 2-1499 LOWER TUBE, 2013 HYUNDAI VELOSTER TURBO 21-2157DK AIR FILTER 2-3/4” FLG, 5-1/2”B, 4-3/4T DRYFLOW 9448 1/2” BNDHOSE CLAMP,2.56”-3.50” 08160 WASHER;...
- Page 3 Read and understand these instructions BEFORE attempting to install this product. Failure to follow installation instructions and not using the provided hardware may damage the intake tube, throttle body and engine. 1. Preparing Vehicle a. Make sure vehicle is parked on a level surface. b.
- Page 4 e. Remove the three M6 bolts f. Firmly grasp the airbox and slide it securing the stock airbox towards the engine to detach from lower chamber. Remove stock intake airbox and tube assembly. g. With the vehicle raised, remove h. Remove the two plastic clips under the three plastic clips in the driver vehicle, near driver’s side front side front wheel well as indicated...
- Page 5 k. From underneath vehicle, l. Carefully lower the intake remove the remaining two M6 resonator and disconnect the tree bolts securing the lower intake mount clip to detach the foglight resonator. harness. Set aside resonator chamber.
- Page 6 3. Installation of AEM Intake System ® a. When installing the intake system, do not completely tighten the hose clamps or mounting hardware until instructed to do so. b. Install the two rubber mounts(I) c. Slide coupler(B) over turbo inlet provided into the previous with two hose clamps(C).
- Page 7 Reinstall lower belly pan cover and plastic well liner. h. Reconnect crank case breather i. AEM cold air intake system hose and recirculation valve hose installed. to upper tube(A) and fasten using stock spring clamps as shown.
- Page 8 3 minutes. Perform a final inspection before driving the vehicle. 5. Service and Maintenance a. AEM Induction Systems requires cleaning the intake system’s air filter element every 100,000 miles. When used in dusty or off-road environments, our filters will require cleaning more often.
- Page 9 AEM intake system is required for redemption of a warranty claim. This warranty is limited to the repair or replacement of the AEM part. In no event shall this warranty exceed the original purchase price of the AEM part nor shall AEM be responsible for special, incidental or consequential damages or cost incurred due to the failure of this product.
Need help?
Do you have a question about the 21-724 and is the answer not in the manual?
Questions and answers