Advertisement
Quick Links
®
Dryflow™ Filter
Equipped with AEM
No Oil Required!
INSTALLATION INSTRUCTIONS
PART NUMBER: 22-631
2000-2002
SATURN
SC2
L4-1.9L
C.A.R.B. E.O. # D-670
* NOTE: Legal in California only for racing vehicles which may never be used upon a highway
AEM Induction Systems
1 (800) 992-3000
WWW: http://www.aemintakes.com
Advertisement
Related Manuals for AEM 22-631
Summary of Contents for AEM 22-631
-
Page 1: Installation Instructions
® Dryflow™ Filter Equipped with AEM No Oil Required! INSTALLATION INSTRUCTIONS PART NUMBER: 22-631 2000-2002 SATURN L4-1.9L C.A.R.B. E.O. # D-670 * NOTE: Legal in California only for racing vehicles which may never be used upon a highway AEM Induction Systems 1 (800) 992-3000 WWW: http://www.aemintakes.com... -
Page 2: Parts List
PARTS LIST Description Qty. Part Number Air Filter Assy. 2.25 X 5" Dry Ele. 21-200DK Short Pipe 2-6311 Hose, Silicone 2.25x3" Blk. 5-225 Hose; 3/8"ID X 14"L 5-1014 Mount, Rubber 1" X 6mm 1228599 Grommet, 3/8" 784633 Washer, 6mm Soft Mount 08160 Nut, M6 Hex Serrated 444.460.04... - Page 3 Read and understand these instructions BEFORE attempting to install this product. Failure to follow installation instructions and not using the provided hardware may damage the intake tube, throttle body and engine. 1. Preparing Vehicle a. Make sure vehicle is parked on level surface. b.
- Page 4 When installing the intake system, do not completely tighten the hose clamps or mounting hardware until instructed to do so. b. Ensure the inside of the AEM inlet pipe and air filter are clean and free from any foreign objects and/or obstructions.
- Page 5 e. Install the rubber mount as shown. Align the Proper installation of the rubber mount intake bracket with the rubber mount stud and assembly. secure with a washer and nylock nut. Do not completely tighten. Refer to the diagram for proper installation.
- Page 6 AEM Air Intake System Warranty Policy ® warrants that its intake systems will last for the life of your vehicle. AEM will not honor this warranty due to mechanical damage (i.e. improper installation or fitment), damage from misuse, accidents or flying debris. AEM will not warrant its powder coating if the finish has been cleaned with a hydrocarbon-based solvent.