Subscribe to Our Youtube Channel
Related Manuals for AEM 22-483
Summary of Contents for AEM 22-483
-
Page 1: Installation Instructions
® Dryflow™ Filter Equipped with AEM No Oil Required! INSTALLATION INSTRUCTIONS PART NUMBER: 22-483 2003-2006 MAZDA 6 V6-3.0L Auto. Trans. Only C.A.R.B. E.O. # D-670... - Page 2 PARTS LIST Description Qty. Part Number Element Parts Kit 2.75 X 5" Dry Ele. 21-202DK Short Pipe 2-4831 Zip Tie, 6 Long 1-113 Cap, Vacuum 3/16 444.130.10 Bolt, Socket 8-32 X 5/16 SS 1-2023 1/2" Bnd. Hose Clamp, 2.56"-3.50" 9448...
- Page 3 Read and understand these instructions BEFORE attempting to install this product. Failure to follow installation instructions and not using the provided hardware may damage the intake tube, throttle body and engine. 1. Preparing Vehicle a. Make sure vehicle is parked on level surface. b.
- Page 4 e. Unplug green connector on the vacuum solenoid. f. Pull vacuum hose off of the nipple on the air box. g. Pull the air box up and out of the engine bay. h. Remove the vacuum solenoid from the air box. Remove the two bolts holding down the air box Remove all vacuum lines from the solenoid.
- Page 5 i. Raise the front of the vehicle with a jack. Refer to j. Remove the four screws on the bottom of the your owner’s manual for proper jack and jack stand fender liner. placement to properly support vehicle. Support your vehicle using properly rated jack stands before wheel removal or while working under the vehicle.
- Page 6 ® 3. Installation of AEM intake system. a. When installing the intake system, do not completely tighten the hose clamps or mounting hardware until instructed to do so. c. Follow the vacuum hose up to the ‘T fitting. Pull b. Release the two hose clamps that hold the the vacuum hose off of the ‘T’...
- Page 7 f. Install the air filter onto the end of the pipe as g. Insert other end of pipe into the stock inlet hose. shown. Place mounting tab under the bolt in the frame rail. h. Install the air flow sensor into the inlet pipe i.
-
Page 8: Service And Maintenance
AEM Dryflow cleaning kit part # 21-110. ® b. Use aluminum polish to clean your polished AEM intake tube. ® c. Use window cleaner to clean your powder coated AEM intake tube. (NOTE: DO NOT USE aluminum polish on powder coated AEM intake tubes).
Need help?
Do you have a question about the 22-483 and is the answer not in the manual?
Questions and answers