Advertisement
®
Equipped with AEM
Dryflow™ Filter
No Oil Required!
INSTALLATION INSTRUCTIONS
PART NUMBER: 21-705
2003-2008
TOYOTA
4Runner
V6-4.0L
SEE * NOTE
* NOTE: Legal in California only for racing vehicles which may never be used upon a highway
AEM Induction Systems
1 (800) 992-3000
WWW: http://www.aemintakes.com
Advertisement
Table of Contents
Related Manuals for AEM 21-705
Summary of Contents for AEM 21-705
-
Page 1: Installation Instructions
® Equipped with AEM Dryflow™ Filter No Oil Required! INSTALLATION INSTRUCTIONS PART NUMBER: 21-705 2003-2008 TOYOTA 4Runner V6-4.0L SEE * NOTE * NOTE: Legal in California only for racing vehicles which may never be used upon a highway AEM Induction Systems 1 (800) 992-3000 WWW: http://www.aemintakes.com... -
Page 2: Parts List
PARTS LIST Description Qty. Part Number Hose Clamp #48 08601 Hose, Silicone 3.00x2” Black 5-302 Tube; 03-08 4runner 4.0L 2-1468 Hose; 4mm ID X 18” L 08153 Bolt; Socket 8-32 X 5/16 SS 1-2023 Bolt; M6-1.00 X 16mm Hex Hd. 07703 Washer;... - Page 3 Read and understand these instructions BEFORE attempting to install this product. Failure to follow installation instructions and not using the provided hardware may damage the intake tube, throttle body and engine. 1. Preparing Vehicle a. Make sure vehicle is parked on level surface. b.
- Page 4 e. Remove the two bolts that secure the resonator to f. Disconnect the two mass air wire harnesses retaining the inner fender, then remove resonator from vehicle as clips from the airbox, then disconnect the mass air shown. sensor electrical connection. g.
- Page 5 k. On vehicles equipped with the A/C mounting bracket, l. Rotate the A/C mounting bracket onto the power remove the A/C mounting bracket and loosen the nut. steering reservoir, then secure it using the bolt from the Then, remove the power steering reservoir mounting previous step.
-
Page 6: Intake System
® 3. Installation of AEM Intake System a. When installing the intake system, do not completely tighten the hose clamps or mounting hardware until instructed to do so. b. Mount the two provided brackets onto the vehicle c. Install the edge trim onto the heat shield as shown. - Page 7 ® h. Remove the two screws that secure the mass air i. Secure the mass air sensor to the AEM intake tube sensor to the airbox assembly, then remove the mass using the provided bolts as shown. air sensor as shown.
- Page 8 Connect the factory crankcase vent hose onto the ® regulator. Install the provided silicone hose, attaching intake tube as shown. the hose to the fuel pressure regulator and the AEM ® intake tube nipple. p. Install the filter adapter into the air filter as shown, q.
-
Page 9: Service And Maintenance
Use aluminum polish to clean your polished AEM ® intake tube. ® c. Use window cleaner to clean your powder coated AEM intake tube. (NOTE: DO NOT USE aluminum polish on powder coated AEM intake tubes). For technical inquiries e-mail us at sales@aemintakes.com... - Page 10 ® warrants that its intake systems will last for the life of your vehicle. AEM will not honor this warranty due to mechani- cal damage (i.e. improper installation or fitment), damage from misuse, accidents or flying debris. AEM will not warrant its powder coating if the finish has been cleaned with a hydrocarbon-based solvent.
Need help?
Do you have a question about the 21-705 and is the answer not in the manual?
Questions and answers