General Safety Warnings - Cisco Catalyst 9800-80 Installation Manual

Preparing Your Site for Installation

General Safety Warnings

Warning Statement 1004—Installation Instructions
Read the installation instructions before connecting the system to the power source
Warning Statement 1040—Product Disposal
Ultimate disposal of this product should be handled according to all national laws and regulations
Warning
Statement 1073—No User-Serviceable Parts
No user-serviceable parts inside. Do not open.
Warning
Statement 1074—Comply with Local and National Electrical Codes
Installation of the equipment must comply with local and national electrical codes.
Warning
Statement 1030—Equipment Installation
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1005—Circuit Breaker
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that the
protective device is rated not greater than:
AC:
• 20 A U.S. maximum
Warning Statement 1045—Short-circuit Protection
This product requires short-circuit (overcurrent) protection to be provided as part of the building installation.
Install only in accordance with national and local wiring regulations.
Cisco Catalyst 9800-80 Wireless Controller Hardware Installation Guide
General Safety Warnings
21