Ec Declaration Of Conformity - Proxxon FF 230 Manual

Setting compound-type table guide play
If, after a time, the compound-type table guide is found to
have too much or too little play, the play can be reset using
the adjusting screws 2 (Fig. 15). For this purpose, loosen
adjustment screw lock nuts 1 and screw in all adjustment
screws evenly until play is eliminated. Retighten lock nuts
afterwards.
Setting compound-type table spindle play
If play of the spindles increases, release the nut 1 using a
socket spanner 2 (Fig. 16) approx. one half turn until play is
eliminated. Then turn the hand wheel to the right hand
direction until the play has been eliminated. Now retighten
the nut 1 firmly (lock).
See exploded view, page 48 Where necessary, play in the
individual spindle threads can also be achieved by slightly
tightening the spindle nut, Item 3, with the bolt, Item 25.
Machine lubrication
To ensure a long service life of your machine, please
observe the lubrication diagram in Fig. 17 (A: Lubricate
each time before use / B: Lubricate once a month). Only
use acid-free machine oil for lubrication.
After use
Important!
Disconnect milling machine mains plug before cleaning.
Risk of injury!
Clean compound-type table and milling machine using a
soft cloth and brush after use. Then lightly oil the guides
and distribute the oil by moving the table. Never use
compressed air for cleaning the compound-type table as
cuttings entering the guides in this manner could destroy
the guides.
Disposal:
Please do not dispose of the device in domestic waste!
The device contains valuable substances that can be
recycled. If you have any questions about this, please
contact your local waste management enterprise or other
corresponding municipal facilities.
Note:

EC Declaration of Conformity

Name and address:
PROXXON S.A.
6-10, Härebierg
L-6868 Wecker
Product designation: PF/FF 230
Article No.: 24104/24108
In sole responsibility, we declare that this product
conforms to the following directives and normative
documents:
EU EMC Directive 2004/108/EC
DIN EN 55014-1 / 05.2012
DIN EN 55014-2 / 06.2009
DIN EN 61000-3-2 / 03.2010
DIN EN 61000-3-3 / 03.2014
EU Machinery Directive 2006/42/EC
DIN EN 61029-1 / 01.2010
Date: 10.06.2015
Dipl.-Ing. Jörg Wagner
PROXXON S.A.
Machine Safety Department
The CE document authorized agent is identical with the signatory.
- 11 -