Proxxon Micromot 230/E Manual
Hide thumbs
Also See for Micromot 230/E:
- Manual (6 pages) ,
- Manual (102 pages) ,
- Translation of the original operating instructions (108 pages)
Advertisement
Quick Links
Advertisement
Related Manuals for Proxxon Micromot 230/E
Summary of Contents for Proxxon Micromot 230/E
- Page 1 MICROMOT 230/E Manual...
- Page 2 Fig. 1 Fig. 2 Fig. 3 Fig. 4 - 3 -...
- Page 3 fi re and/or serious injury. device and its functions. b) Do not use accessories which are not speci- Proxxon assumes no liability for the safe fi cally designed and recommended by the tool function of the device in the case of: manufacturer.
- Page 4 drum for cracks, tear or excess wear, wire such as dowel rods, pipes or tubing have a tenden- brush for loose or cracked wires. If power cy to roll while being cut, and may cause the bit to tool or accessory is dropped, inspect for bind or jump toward you.
- Page 5 pinched by the workpiece, the edge of the wheel a) Use only wheel types that are recommen- that is entering into the pinch point can dig into ded for your power tool and only for recom- the surface of the material causing the wheel to mended applications.
- Page 6 The protruding wheel may cut gas or water pipes, 2 Description of the device: electrical wiring or objects that can cause kick- back. The Micromot 230/E is ideally suited to tasks Safety warnings specifi c for wire brushing such as precision drilling, milling, grinding, operations:...
-
Page 7: Technical Data
5 Commissioning: contact pressure! • By tendency: Bits and cutters with smaller Your Micromot 230/E is ready to use on delivery. diameters require higher speeds than those Apart from clamping the operational tools, no with a larger diameter. - Page 8 5.1 Adjusting the operational tools (Fig. 2) 5.3 Working with the device A collet chuck suitable for a shaft diameter of Caution: 2.4 mm is fi tted ex works to the spindle collet Never work without safety glasses. holder. This is the preferred diameter for Prox- Do not work with damaged grinding disks xon operational tools.
- Page 9 The mains power input may only be replaced by 1. Activate the device with the switch 1 (Fig. 1) and our Proxxon Service Department or a qualifi ed set the right speed for the work on the knob 2. specialist! 2.
- Page 10 6 EC Declaration of Conformity Name and address of the manufacturer: PROXXON S.A. 6-10, Härebierg L-6868 Wecker Product designation: Micromot 230/E drilling and milling device Article number: 28440 On our sole responsibility, we declare that this product conforms to the following...
- Page 11 Spare Parts List - 102 -...
- Page 12 - 103 -...
- Page 13 Service note All PROXXON products are thoroughly inspected after production. Should a defect occur nevertheless, please contact the dealer from whom you purchased the pro- duct. Only the dealer is responsible for handling all legal warranty claims which refer exclusively to material and manufacturer error.