Table of Contents
Advertisement
Inserting Batteries
To install batteries into the Advanced Cable Gateway:
Parts and Putting them Together
1.
Ensure the power cord is
unplugged. Remove the battery
cover on the rear panel. There
are two battery compartments.
One battery is included with the
Advanced Cable Gateway.
For an additional battery please
contact your local operator.
2.
Push the slider up/down to allow
for battery insertion.
3.
Insert the battery into the
compartment marked
"Battery 1".
4.
Readjust the slider to prevent the
battery from moving and replace
the battery cover. Plug the power
cord into an electrical outlet that
is not controlled by a wall switch
(this will assure that the unit has
uninterrupted power). The battery
will fully charge within 5 hours.
15
Advertisement
Table of Contents
