Table of Contents
Advertisement
3. Inserting batteries
To install batteries into the ACG905:
1. Ensure the power cord is unplugged. Remove the battery cover on the rear panel.
There are two battery compartments. One battery is at your disposal in your box
content. For an additional battery please contact your local operator.
2. Push the slider up/down to allow the battery insertion.
3. Insert the delivered battery into the compartment marked "Battery 1".
4. Readjust the slider to prevent the battery from moving and reattach the battery
cover.
Plug the power cord into an AC-receptacle that is always ON (non-switchable). The battery
User Manual ACG905 – draft
About your Advanced Cable Gateway
will fully charge within 4 hours.
9
Advertisement
Table of Contents
