Toshiba 5000 SERIES Installation And Operation Manual page 80

Display
DEFCAL Touchscreen is using default val-
ues instead of calibrated values.
DLYSTRT Delay Start – UPS is counting
UP down prior to startup.
EE1ST EEPROM is loaded with default
values.
EPO EPO circuit is active.
EQCHRG Equalized Charging
FLT A fault has occurred.
FRCDBYP UPS forced into bypass mode.
Many fault codes can cause
a transfer to Bypass (e.g. Batt
Shutdown, Phase Rotation Error)
See Appendix B - Command
Table for additional information.
FWUPD Firmware updated.
INVSTUP UPS starts up in inverter mode
(skips bypass)
INV Inverter mode.
LANSD UPS goes to Shutdown triggered
from LAN SD (shutdown) circuit.
LB Low Battery – The battery volt-
age has dropped low (about 90%
or less) during operation. Con-
tinued operation in this mode will
deplete battery and cause output
shut down. (This can be adjusted
by the operator
LCRUN Local run command issued.
MANUAL UPS is in Manual mode
OUT50HZ UPS set for 50 Hz Output.
PFAIL Input power failure.
PRCHRG Protective charging
RMRUN Remote Run command issued.
RMTSD Remote shutdown occurred.
RMTSWEN Remote switch control enable.
SYN Synchronous mode.
TIMEDSD UPS is counting down prior to
shutdown.
WRN A warning has occurred.
70
5000 System Status Messages
Meaning
No action needed.
No action needed.
No action needed.
Reset EPO switch to start.
No action needed.
See Fault records.
Secure the load and contact the nearest Toshiba
authorized representative for service.
No action needed.
No action needed.
Inverter is running (it can be On-Line, Battery Test, or
Backup)
Deactivate LAN shutdown signal to reset.
Immediately shut down the load equipment in an
orderly fashion and then press the STOP key.
No action needed.
No action needed.
No action needed.
No action needed.
No action needed.
No action needed.
One or more warnings occurred. Check the Warnings
field for details. Disconnect LAN signal to reset.
No action needed.
Input and output are synchronized.
Immediately shut down the load equipment in an
orderly fashion and then press the STOP key.
See Warning record.
5000 Series NEMA-3R 3-Phase UPS Installation and Operation Manual – 92975-000
Action