Environmental Declaration - Solid State Logic A16.D16 User Manual

A16.D16, A32 and D64 User Guide
Environmental Declaration
The symbol shown here, which is on the product or its packaging, indicates that this
product must not be disposed of with other waste. Instead, it is the user's responsibility to
dispose of their waste using a designated collection point for recycling of waste electrical
and electronic equipment. The separate collection and recycling of your waste equipment
at the time of disposal will help to conserve natural resources and ensure that it is
recycled in a manner that protects human health and the environment. For more
information about where you can dispose of your waste equipment for recycling, please contact your
local city office, your household waste disposal service or where you purchased the product.
RoHS Notice
Solid State Logic has conformed and this product has conformed to European Union's Directive
2011/65/EU on Restrictions of Hazardous Substances (RoHS) as well as the following sections of
California law which refer to RoHS, namely sections 25214.10, 25214.10.2, and 58012, Health and
Safety Code; Section 42475.2, Public Resources Code.
For USA
To the User:
1. Do not modify this unit! This product, when installed as indicated in the instructions
contained in the installation manual, meets FCC requirements.
2. Important: This product satisfies FCC regulations when high quality shielded cables are used
to connect with other equipment. Failure to use high quality shielded cables or to follow the
installation instructions may cause magnetic interference with appliances such as radios and
televisions and will void your FCC authorisation to use this product in the USA.
3.
Note: This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct
the interference at his own expense.
Electromagnetic Compatibility
EN55103-1:2009, EN55103-2:2009 Environments E1, E2, E3 and E4
Typical average initial half-cycle inrush current: 1.3 A. Typical peak inrush current: <5 A.
The audio input/output and network ports are screened-cable ports and any connections to them
should be made using braid-screened cable and metal connector shells in order to provide a low
impedance connection between the cable screen and the stagebox. All network connections should
be of Cat5e standard or above.
Environmental
Temperature Operating: +5 to 30 deg. C
Vibration Operating: < 0.2 G (5–200 Hz)
Shock Operating: < 3 G (11 ms max.)
Storage: -20 to 50 deg. C
Non-operating: < 0.4 G (5–200 Hz)
Non-operating: < 10 G (11 ms max.)
Contents
Page 26 of 26