Wifi Configuration - La Cimbali M39 Dosatron TE Engineer's Manual

These are the washes where the time can be programmed, each of
which contains two modifiable settings, including:
WASH1
hour
coffee stop
Changing the water in the boiler is a daily programmable change:
 WASHING OPTIONS
Refill
Wi-Fi Menu - Configure the following Wi-Fi settings as shown below:
- CONNECT - to connect to the access point selected.
- RSSI - signal intensity:
Values less than -70 dB indicate poor coverage with probable difficulty in transmitting data.
- IP - Displays the IP address assigned to the machine by the wireless access point.
- Net - enter the name of the access point.
- Security - indicate the type of wireless network security:
Open: no protection;
WPA: wpa2-psk protection;
WEP: WEP 128 protection.
- Key - enter the password to access a protected Wi-Fi network (WPA or WEP)
- URL - enter listener.gruppocimbali.com.
- Port - enter 10000.
- RESET - To restore the parameters to the standard settings.
Service hours
Washing Groups 1, 2, 3
15:30
+ 
YES
Changing the water in the boiler
+ 
18:30

WiFi configuration

- time: the time that washing must take place.
The WASHES can be deactivated by setting to OFF.
- block coffee: when the function is set (YES), if washing has not been
performed within 60 minutes of the "PERFORM GROUP WASH"
message being displayed, the machine is blocked, disabling all coffee-
based selections.
NOTE: missing wash 1s will be stored in the "WASH 1 ARCHIVE" as
washes not performed.
- time: the time that the change must take place.
THE WATER CHANGE feature can only be activated by the technician
and is always set to OFF. It must first be activated and then under
"WASHING OPTIONS" (in time panel) it can be changed, or it can be
changed by the technician.
9 EN