Before performing this operation, turn off the machine and set CPU board
DIP switch 1 to ON, and then turn the machine on.
Under the item "DIP settings", the following DIP switch positions are
displayed:
DIP SETTINGS
1
2
3
4
If there is WiFi, the following is displayed at "IP":
INFO
SERIAL N°
VERSION SW
SETUP
DIP SETTINGS
IP
Entering Standard Data
Dip settings
ON
OFF
5
6
7
8
+
During Standard Data entry, several parameters are to be set based on
the model and type of the machine:
- TYPE: 2, 3, 4 groups;
- TURBOSTEAM YES/NO;
Using the keys
and
choose the settings and then press the
to confirm the entry.
At the end of the operation, turn the machine off and reset CPU board
DIP switch 1 to OFF.
Then:
- turn the machine on again
- set the date and time and, if necessary, the desired language
- reset the maintenance parameters, if desired
(see "Configuration Menu - Maintenance")
- Reset the archive.
- Press and hold OK for several seconds to activate/deactivate
resistance.
Under standard conditions, the DIP switches are set to OFF.
- DIP 1 =
OFF - ON standard data entry
- DIP 2 =
OFF
- DIP 3 =
OFF - ON technical key simulation
- DIP 4 =
OFF - ON access to accounting functions
- DIP 5 =
OFF - ON enabling of key sequence for
programming entry
- DIP 6 =
ON
- DIP 7 =
OFF
- DIP 8 =
OFF
For more details, please see the technical manual in the section
"Settings - CPU DIP switches".
IP
IP - displays the IP address assigned to the machine by the wireless
access point.
24 EN
key