Self. Learning Clone - La Cimbali M39 Dosatron TE Engineer's Manual

Press the key .
Place the cup or cups underneath the filter-holder nozzles and press the
key to be programmed, holding until
the desired level is reached in the cup or cups.
During this phase, the value of the impulses of the volumetric dosing device
(top right on the display) is increased; when the key is released,
the value reached is stored and appears on the display.
 TECHNICAL PROG.
KEY MENU
Self. learning
CONFIGURATION
TESTING
 CONFIGURATION
Bolier press.
Low power NO
Sensitivity level
MEASURING UNIT
Drying
Boiler pressure - indicates the pressure of the boiler; 0.6 to 1.6 bar
(9 to 23 psi)
Low power - YES/NO
Sensitivity level - indicates the degree of sensitivity of the level probe,
which then operates the filling of the boiler with water. For safety
reasons, automatic level control of the boiler is disabled when the
boiler resistance is turned off.
- Note: set a value of 1 if the machine is installed with very conductive
water.
-Note: set a value of 3 if the water used is not very conductive (very soft).
MEASURING UNIT – includes 2 sub-menus
Temperature – c an be set to °C Celsius centigrade or °F Fahrenheit
degrees.
Pressure – can be set to bar or psi.
Drying - wafer drying time from 0 to 5 with steps of 0.1 seconds "if
Drying kit is present".
 CONFIGURATION
Time check
buzzer SI
Custumer prog.
progr. block
Dispensing Stop
5. Self. learning - Clone
CLONE FUNCTION
This function allows coffee dose settings of the right group to be
copied to all other groups.
Once programming of the right group is complete, push OK.
At the end of the process, all the groups will have the same settings.
+ 
6. Configuration menu
Time check - view dispensing time on the display: YES/NO
1.3 bar
+ 
2
Buzzer - enables/disables all audible signals when keys are pressed or
messages are displayed: YES/NO.
05.0s
Customer programming - customer programming: YES/NO
Block programming - block programming: YES/NO. When this function
is activated (YES), the programming keypad can only be used by
accessing the technical menu
Stop dispensing: enabled - YES/NO.
YES: each dispensing key performs start/stop.
This means that pressing the same button during dispensing interrupts it
Payment system – permits configuration of payment system, when
connected.
WASHING OPTIONS - See paragraph "Washing options" on the
following pages.
NO
+ 
RESIN regeneration - includes the resin regeneration settings: litres
of resin (from 0.1 l to 25 l), hardness (from 0 to 45 °F).
SI
NO
NO
7 EN
 CONFIGURATION
Paym. system
WASHING OPTIONS
Resin regeneration
MAINTENANCE
DATA IN/OUT
NO
+ 