Page 1
WINDSOR ommodore 01) Install jets and brush. 02) Fill solution tank with extrac- Make sure that the handle is in the upright po- sition and adjust the brush height by pushing tion rinse or fresh water. down on the vacuum shoe and turning the lever and castle nut.
Page 2
WINDSOR ommodore 01) Drain solution tank. 02) Drain recovery tank. 03) Rinse out and clean recovery tank. MAINTENANCE 04) Clean mesh water filter and 05) Clean float shut off. 06) Remove jets and soak in a 07) T : remove vaccum o Clean brush water filter cap.