Playback - Sony SNC-HMX70 User Manual

Playback

Click PLAYBACK in the application bar to view,
search or export recordings. This link is only visible if a
direct iSCSI or memory card has been configured for
recording. (With VRM recording this option is not
active.)
The panel on the left has four groups:
– Connection
– Search
– Export
– Track list
Selecting the recording stream
On the left side of the browser, expand the Connection
group if necessary.
To view a video input channel:
1
Click the Video Input to see the options.
2
Select the video channel you wish to view.
To view a circular or dewarped image for the full image
circle:
1
Click the Dewarping arrow to see the options.
2
Select E-PTZ or Off.
To view a recording stream:
1
Click the Recording arrow to see the options.
2
Select recording stream 1 or 2.
Searching for recorded video
On the left side of the browser, expand the Search group
if necessary.
1
To limit the search to a particular time range, enter
the start and stop date and times.
2
Select an option from the drop-down box to define
a search parameter.
3
Click Start Search.
4
The results are shown.
5
Click a result to play it back.
6
Click Back to define a new search.
Exporting recorded video
On the left side of the browser, expand the Export group
if necessary.
1
Select a track in the track list or in the search
results.
2
The start and stop date and time are filled-in for the
selected track. If required, change the times.
3
In the Time lapse drop-down box, select the
original or a condensed speed.
4
In the Location drop-down box, select a target.
5
Click Export to save the video track.
Note
The target server address is set on the Network /
Accounts page.
Controlling playback
The time bar below the video image allows quick
orientation.
The time interval associated with the sequence is
displayed in the bar in gray. Arrows indicate the position
of the image currently being played back within the
sequence.
The time bar offers various options for navigation in and
between sequences.
– If required, click in the bar at the point in time at which
the playback should begin.
– Change the time interval displayed by clicking the
plus or minus icons. The display can span a range from
two months to a few seconds.
– Click the alarm jump buttons to go from one alarm
event to the next or to the previous one. Red bars
indicate the points in time where alarms were
triggered.
Controls
Control playback by means of the buttons below the
video image.
The time code is displayed on the left above the
full-screen icon. The buttons have the following
functions:
– Start/Pause playback
– Select the playback speed using the speed regulator
– Jump to start of active sequence or to previous
sequence
– Jump to start of the next video sequence in the list
8