10/100Mbps Ports With M12 Interface Cable Pinout - Planet ISW-800T-M12 User Manual

Please follow the steps below for DC power cable installation on Industrial M12
Ethernet Switch.
1. Plug the DC power cord connector to the power input port of the Industrial M12
Ethernet Switch.
2. Screw the nut on DC power cord female connector to the DC power input male
connector of Industrial M12 Ethernet Switch and make sure the connection is
tight.
Before DC power cord connection, please check and assure your
local DC power source is stable.
Note

2.1.5 10/100Mbps Ports with M12 Interface Cable Pinout

The Industrial M12 Ethernet Switch front panel provides provide eight RJ-
45 10/100Mbps ports M12 interfaces, these ports are designed for Ethernet
equipments connection. The Industrial M12 Ethernet Switch 10/100Mbps M12 input
interface pinout is shown as below
ISW-800T-M12/ISW-804PT-M12
Pinout 1: TX+
1 2
TX RX
Pinout 2: RX+
RX TX
Pinout 3: TX -
4 3
Pinout 4: RX -
Please follow the steps below for 10/100Mbps M12 cable installation on Industrial
M12 Ethernet Switch.
1. Plug the 10/100Mbps M12 cable male connector to the Ethernet female
connector input port of the Industrial M12 Ethernet Switch.
2. Screw the nut on 10/100Mbps M12 cable male connector to the Ethernet input
female connector of Industrial M12 Ethernet Switch and make sure the connec-
tion is tight.
Due to per Ethernet port of Industrial M12 Ethernet Switch is
running at auto negotiation mode. Please assure the opposite
Ethernet devices Ethernet ports are running at auto negotiation
Note
mode also, otherwise, the Ethernet performance will be poor.
Pinouts for the RJ-45(8-Pin) Port
RJ-45(8-Pin)
Pin
1
1 8
2
3
6
Singnal
MDI MDI-X
TX+ RX+
TX - RX -
RX+ TX+
RX - TX -
15