Condensate Drain Connection - Wolf Steel Condo Pack Installation And Operating Instructions Manual

4.8

CONDENSATE DRAIN CONNECTION

The furnace and air conditioning condensate drain connections are included, but not installed. Both
drain connections are already pre-fabricated with integral P traps. To connect condensate drains to
the existing drainage systems, refer to illustrated installation steps 1-17:
1
A1
A2
B
4
A2
A1
1/2"ID
Pull two clamps C over A1&A2 hose ends.
7
E
Remove both caps E
from the top of T fittings F.
F
A1
10
After adding water,
PLACE CAPS BACK
onto barbed T fittings.
E
F
A1 A2
11
2
A
A - Furnace
Hoses:
A1 = 1/2" ID
A2 = 5/8" ID
B - AC Hose:
C - Hose Clamp 2X
B = 5/8" ID
A /A
- Furnace Hoses
1 2
5
A
1. Remove two
caps (not shown)
from the bottom
C
of barbed
5/8" ID
T fittings F.
Connect A1&A2 hose openings
to T fittings and tighten both clamps.
8
A
A2
A1
A2
Check drain hoses
CAPS COVERING BARBED FITTINGS SHALL ONLY BE REMOVED
inside. Ensure the
DURING PRIMING OF THE P-TRAP, THEY MUST BE FIRMLY IN
clamps are tightly
PLACE COVERING BARBED FITTINGS DURING UNIT OPERATION.
clamped to fittings.
IN ADDITION, ALL DRAIN TUBES MUST BE TIGHTLY CLAMPED
TO THE BARBED FITTINGS.
FAILURE TO FOLLOW EITHER OF THESE CONDITIONS
DURING UNIT OPERATION COULD CAUSE EXHAUST PRODUCTS
TO ENTER THE LIVING SPACE WHICH MAY RESULT
IN PROPERTY DAMAGE, PERSONAL INJURY OR DEATH.
Add water into
12
drain B opening.
A2
5/8" ID
A1
C
1/2" ID
F
A
A 2
1
Prep hose by
adding RV grade
plumbing antifreeze
into both A1&A2
hose openings until
liquid starts dripping
from the other end.
F
Drain extra liquid.
WARNING
!
In order for air conditioner
to operate, this trap has to be
filled with water as shown.
3
B
C
C - Hose Clamp 1X
ID
B - AC Hose = 5/8"
6
A
A2
D
A1
Navigate hoses A1&A2 INSIDE of support
bracket D as shown. Mount bracket D into
position and secure it with screw provided.
9
In order for furnace to operate,
this trap has to be filled
with water as shown.
A2
A1
!
W415-1307 / B / 03.31.2017
13
27
IOM