Packaged Unit Installation - Wolf Steel Condo Pack Installation And Operating Instructions Manual

24
4.6

PACKAGED UNIT INSTALLATION

Procedure
IOM
IOM
1� Verify that isolation grommets are installed in the five holes on the
top mounting bracket.
2� Bring the Condo Pack as close as possible to wall opening
(FIG. 4�6�A). Carefully slide the unit into the Wall Sleeve (refer to
section 4.4. "Wall Sleeve Assembly" and Installation Instructions)
so the front of the unit is in contact with the front flanges of the
Wall Sleeve�
For ease of installation (OPTIONAL):
a� Install cabinet into the Wall Sleeve without cooling unit.
b. Slide cooling unit in, after cabinet is in place (FIG. 4�6�B)
c� Furnace module also can be removed separately (FIG. 4�6�C)�
AC Module
Furnace
Module
3� Use a flat washer with each 1/4"-20 x 1 1/4" screw. Secure Condo
Pack unit to the Wall Sleeve using five 1 1/4" screws through
the isolation grommets in the five holes on the Wall Sleeve top
mounting bracket (see FIG. 4�6�D)�
DEFORM THE ISOLATION GROMMETS AND
4� Caulk and seal all spaces around the top, sides and bottom of the
exterior grille area, making sure that the openings for drainage in
the bottom edge are not blocked.
5. Shim (FIG. 4.6.E) between unit support (Diagram B) and the bottom
rear corners of cabinet to prevent twisting loads onto structural walls.
W415-1307 / B / 03.31.2017
Refer to section "4.16.4.2 Furnace Module Removal"�
NOTE
OVER-TIGHTENING THE SCREWS WILL
REDUCE THEIR EFFECTIVENESS.
Air Conditioning module removal.
Air Conditioning module can
be removed for easier cabinet
installation. Refer to section "4.16.4.1
Air Conditioner Module Removal".
Furnace module removal.
Furnace module can be removed
from cabinet separately. Refer to
section "4.16.4.2 Furnace Module
Removal"�
Both modules can be installed
separately and either one of these
can be replaced as a service part
(as the complete modules).
1/4"-20 x 1 1/4"
Grommet
Flat Washer
FIG. 4.6.A
FIG. 4.6.B
FIG. 4.6.C
FIG. 4.6.D
FIG. 4.6.E