Installation instructions Please read this instruction manual carefully in order to obtain the best results from the use of the wall canopy. Installation instructions User Screw M6 x 40 mm (incl. washer) (4 guide manual (1) Rangehood (1) https://producthelp.fisherpaykel.com/au/Cook/Rangehoods/Slideout/HS60XW4/User_Guide_HS60XW4/02_Installation_instructions Updated: Fri, 04 Jan 2019 03:33:26 GMT Powered by...
Product Dimensions (HS60LRX4, HS90X4, HS60XW4, and HS60LXW4) Property (mm) HS60LRX4 HS90X4 HS60XW4 HS60LXW4 A. Overall height of product B. Overall width of product C. Overall depth of chassis D. Overall depth of chassis (fully extended) E. Height of handle F. Installed chassis height...
Panel heights Positioning Minimum Clearances Recirculated (HS60LRX4 and HS60LXW4) & Ducted (HS60XW4, HS60LXW4, and HS90X4) Property (mm) Recirculated Ducted A. Height (top of cooktop to base of rangehood) min. 600 – max. min. 600 – max. Electric cooktop Gas cooktop min.650 –...
Property (mm) Recirculated Ducted min. 283 C. Depth of installation (cabinet cavity) min. 283 D. Height of installation (cabinet cavity) max. 108 max. 138 Venting options Attention should be given to ensure that any applicable regulations concerning the discharge of exhaust air are fulfilled.
Page 6
Ducting through cavity to side Recirculating Recirculating installation is recommended only when vented installation is not possible. • HS60LRX4 is designed for front recirculating installations only. • HS60LXW4 can be installed in front recirculating, or can be ducted. Accessories are required.
* In recirculating mode you must use carbon filters to eliminate cooking smells and tall handle (70 mm). Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards. Fig.1 Preparing for install Installation 1.
Page 8
• Place adaptor in top extraction. • Place cover on rear extraction. Front Recirculating installation • (HS60LXW4, HS60LRX4) If the rangehood is to be installed as a recirculating hood: • Remove cover tape (A), see Fig.1. • Place covers on rear and top extraction.
Need help?
Do you have a question about the HS60LRX4 and is the answer not in the manual?
Questions and answers