SATO CX Series Programming Manual page 106

SATO CX Series Printer
A Protocol Command code status label will be printed as a re-
sult of the a successful download of a custom set of Protocol
Command codes.
Special Notes:
1. Commas must be used to separate the parameters. If a
2. This command must be sent as an independent data
3. If more or less than nine commas are included in the
4. If two characters are specified for a parameter, it will be
5. If a combination of characters are outside the hexadeci-
6. The current protocol command codes may be verified by
98
STX=7B
ENQ=23
OFFLINE=7E
Press the "FEED" key to activate the User
Defaults, or Power OFF to ignore them.
parameter is omitted between two commas, the default
Non-Standard Protocol Command codes for that para-
meter will be used.
stream immediately following the <ESC>A Start code
and immediately preceding the <ESC>Z Stop code. No
other commands can be included in the data stream.
command, the entire command sequence will be igno-
red. The command must contain exactly nine commas.
interpreted as a hex value.
mal range, the entire command sequence will be igno-
red.
printing a self test label (<ESC>CT).
ESC=25
ETX=7D
CAN=26 NULL=2A