SATO CX Series Programming Manual page 59

Printer Output:
Special Notes
1. It is effective only for the current data stream.
2. When printing lines or boxes in the same data stream
3. This command is invalid only if the value specified is
4. Following this command with a <CR> character will
with the Line Feed command, the Lines and Boxes com-
mand should be specified last, preceding <ESC>Q
Quantity command.
zero.
allow you to print with auto line feed. The print position
will be determined from the value specified and the H
value set in the printer. If you specify several H values
after this command, the print position will be determined
by the H value last specified. You must redefine the font
to be used after each H command.
SATO CX Series Printer
51