Controls, Indicators, And Connections; Printer Power Connection - SATO CX208 User Manual

Controls, Indicators, and Connections

evice Name Primary Function
EED Button Advances print media
READY Shows printer status
Indicator
Places printer in On-Line
ON-O Button or Off-Line mode
Power Input Connects to power supply
Serial Port Data input
Parallel Port Data input
Print Head
Unlocks print head
Release
Protects print media and
Top Cover
mechanism

Printer Power Connection

1. Plug the output of the AC power supply
provided with the printer into the connec-
tor on the bottom panel.
2. Connect the supply into an AC outlet
having the proper voltage.
ote:
Note :
CX208/212 printers consume very little power
CX208 printers consume very little power
when idle, so are not equipped with a power
when idle, so are not equipped with a power
switch. Pressing the READY indicator/O -OFF (a
switch. Pressing the READY indicator ON-OFF (a
combined control) will reset the printer and switch
combined control will reset the printer and switch
it from Off-Line to On-Line mode.
it from Off-Line to On-Line mode.
Important!
The required AC voltage is marked on the power supply.
Confirm that your AC voltage matches the power supply
requirements. Do not use any power supply other than
the one provided with the printer.
Use
PRESS - to advance media
PRESS while pressing READY
indicator - to print test label
PRESS - to pause printing during
batch mode operation
GREEN - Printer ready for data
O - Printer busy, or Off-Line
RED - Printer needs attention
PRESS to switch to/from Off-Line
or to reset the printer
Connect to transformer provided
with printer
DB9 female connector for
connection to host controller,
RS232 interface
Centronics compatible connector
for connection to host controller
Push both releases toward rear
of printer to release print head
Lift to open
Push outward at hinge to remove