Elation PLATINUM BEAM 5R EXTREME User Manual page 28

EDIT PROGRAM – Record Controller – Working With Built In Programs
A Master unit can send up to 3 different data groups to the Slave units, i.e. a Master unit
can start 3 different Slave units, which run 3 different programs. The Master unit sends the
3 program parts in a continuous loop.
The Slave unit receives data from the Master unit according to the group which the Slave
unit was assigned to. If e.g. a Slave unit is set to "Slave 1" in the menu "Set to Slave", the
Master unit sends "Auto Program Part 1" to the Slave unit.
If set to "Slave 2", the Slave unit receives "Auto Program Part 2".
To start an Auto Program proceed as follows:
1. Slave Setting
• Select "Function Mode".
• Press ENTER to confirm.
• Select "Set to Slave".
• Press ENTER to confirm.
• Select "Slave 1", "Slave 2" or "Slave 3".
• Press ENTER to confirm.
• Press MODE/ESC in order to return to the main menu.
2. Automatic Program Run
• Select "Function Mode".
• Press ENTER to confirm.
• Select "Auto Program".
• Press ENTER to confirm.
• Select "Master" or "Alone".
• Press ENTER to confirm.
• Press MODE/ESC in order to return to the main menu.
28