Cooking Double/Triple Quantity With Memory; Manual Operations; Time Cooking - Sharp R-CD1800M Operation Manual

Cooking double/triple quantity
with memory
Double (triple) quantity means the best time for
cooking two (three) servings or twice (three times)
the amount programmed in the memory pad; it is
not double (triple) the time.
* Suppose you want to cook 3 servings with
memory number 2 pre-programmed Direct start.
Procedure
x2/x3
x2/x3 x 2
1 Place food in oven.
Press the DOUBLE/TRIPLE QUANTITY
pad twice.
2
2 Enter memory number.
Note: If your programmed time is over maximum
time at Double or Triple Quantity, EE9 will
be displayed and you cannot use Double or
Triple Quantity for the memory therefore

MANUAL OPERATIONS

Time cooking

Your oven can be programmed for up to 4 cooking
sequences and has 11 preset microwave power
levels.
Total cooking time
Is it possible to write these two sentences in one line?
For example
Total cooking time
Microwave 100% - 60% Maximum of 60 minutes
Microwave 50% - 10% Maximum of 120 minutes
(Please see page E-20)
Microwave Power Level
Press the SELECT APPROXIMATE
POWER PAD ONCE PERCENTAGE
THEN TOUCH OF POWER
SELECT POWER 100%
9
8
7
6
5
4
3
2
1
0
* Suppose you want to cook for 2 minutes and
30 seconds at 50%.
Display
90%
80%
70%
60%
50%
40%
30%
20%
10%
0%
9
press the STOP/CLEAR pad to cancel and
reduce the multiplication. See page xx.
NOTE for Cooking Double/Triple Quantity with
Memory:
When the DOUBLE/TRIPLE pad is pressed
once, 2 servings are set and the DOUBLE/
TRIPLE pad is pressed twice, 3 servings are set.
Express Defrost with memory
*Suppose you want to cook with memory 0 ,
which was programmed for 10 minutes at Express
Defrost sequence, pre-programmed Direct Start.
Procedure
0
1 Place food in oven.
Enter memory number.
Midway through the defrosting cycle, CHECK will
light in the display and an audible signal will be heard
depending on the setting. You may open the door,
turn food over and shield any warm portions. Close
the door and press the START pad.
Procedure
SELECT
TIME
2 3 0
1 Place food in oven and press the SELEC TIME
pad. Enter cooking time.
SELECT
SELECT
POWER
POWER
2 Press the POWER pad and enter power level.
START
3 Press the START pad.
NOTES :
Cancellation :
The cooking is stopped immediately when the
door is opened.The cooking data remains but
it will be canceled after 1 minute if you do not
operate anything.
the SELECT POWER pad :
It is not necessary to press the SELECT POWER pad
for 100% on single stage, 1st stage and the last stage
in Multi Sequence cooking.
Over the maximum time (EE9) :
If the cooking time is over the maximum time, EE9
will be displayed, therefore to cancel it press the
STOP/CLEAR pad.
SELECT
TIME
5
START