Receiving And Ending Video Calls - MBTelehealth SX10 User Manual

Receiving and Ending Video Calls

Receiving Calls
Your SX Series with Touchpad 10 solution has been configured to automatically accept all
incoming connection requests. This means that both site to site connections initiated by
another site and multi-site connections will be automatically connected .
confirm if your particular equipment has been configured this way.)
You will hear a dial tone that indicates there is an incoming call and your microphone will
automatically mute so that the connecting site cannot overhear what you are discussing . Once
the connection is made, you will need to unmute your microphone so that the other site(s) can
hear you .
Ending Calls
At the completion of every call, press End to disconnect .
TIP
If you are participating in a multi-site event (3 or more participating sites) you will
be automatically connected by the MBTelehealth service desk at the scheduled start time .
Do not attempt to connect to another location .
You will be automatically disconnected at the scheduled end time . ***There will be a 10 minute
warning prior to the disconnection .
When your unit accepts a call it turns the microphone off so you will need to 'unmute" when your
session starts
.
MBTelehealth - SX10/20 with Touchpad10 User Guide
Receiving and Ending Video Calls
(Note: Contact your FES to
Page 16 of 19