Xylem NiCaVis 705 IQ Operating Manual page 20

Commissioning
Menu item
Response time t90
Cleaning mode
Cleaning type
Cleaning duration Air
Save and quit
20
Settings
3 ... 60 min
On

Off

Ultrasound

Air

Ultrasound+air

0,5 ...10 ... 300 s
-
Explanations
Response time of the signal smoothing.
Depending on the sample matrix, mea-
sured values can vary more or less
strongly (e.g. due to foreign bodies or
air bubbles).
The signal filter (here, the
)
time t90
reduces the limits of variation
of the measured values.
Response time t90
The
time after which 90 % of a signal
change are displayed.
This menu item is only available with:
Signal smoothing
=
The specified time is used as a guide
value for low (10 min) to high (60 min)
signal smoothing and can deviate from
the value that was set.
Switching on/off the automatic, time-
controlled cleaning function.
Cleaning methods / adjustment time
This menu item is only available with:
Cleaning mode On
=
The duration of the cleaning procedure
with air is set in the menu item
duration Air
.
This menu item is only available with:
Cleaning type Air
= and
Cleaning type Ultrasound+air
=
For this setting to come into effect, the
Settings of outputs and links
setting
Relay function Sensor controlled
/
Puls duration Automatic
/
selected for the linked relay.
Please note the software requirements
for the components with relay outputs,
MIQ/CR3, MIQ/R6, MIQ/CHVPlus,
DIQ/S 182, DIQ/S 28X (see section
3.1).
The system confirms the saving of the
settings and the display switches to the
next higher level.
NiCaVis 705 IQ
Response
specifies the
On
Cleaning
/
/
has to be
ba75953e03 05/2017