Xylem NiCaVis 705 IQ Operating Manual page 15

NiCaVis 705 IQ
Connecting the
sensor to the sensor
connection cable
ba75953e03 05/2017
1. Take the protective caps off the plug connections of the sensor and the
SACIQ (SW) sensor connection cable and keep them safe.
2. Plug the socket of the SACIQ (SW) sensor connection cable onto the
plug head connector of the sensor. At the same time, rotate the socket
so that the pin in the plug head connector (1) clicks into one of the two
holes in the socket.
3. Then screw the coupling ring (2) of the sensor connection cable onto
the sensor up to the stop.
1
Fig. 3-5 Connect the sensor
SACIQ (SW)
2
Commissioning
15