1: Main Power Supply; System Cabinets; Compatible Equipment - Notifier AFP-3030 Installation Manual

System Cabinets

2.4.1 Main Power Supply
The NPS-5CHS or NPS-11CHS power supply provides a total of 5.6 A or 11.7 A to the CPU and
has a built-in charger. During normal operation, the NPS can recharge batteries ranging in capacity
from 7 to 85 amp-hours.
See Section 3.10, "Connecting Power Sources and Outputs", on page 22 for basic power
information.
2.5 System Cabinets
The CPU and modules are installed in a CAB650, CAB900 or U-Series backbox, holding up to four
rows of equipment plus batteries (up to two 85AH batteries). Backboxes can be ordered with
windowed or solid doors. The doors of the 28U and 40U can be mounted on the left or the right side
of the cabinet. A trim ring option is available for semi-flush mounting.
External measurements for each cabinet backbox are provided in Appendix B, "Cabinet and
Mounting Information", on page 39. Refer to the CAB650, CAB900, or U-Series documentation for
dimensions and door mounting specifications.

2.6 Compatible Equipment

Compatible Notifier and System Sensor equipment that connects directly to the CPU is listed
below. These are the most common devices at time of publishing; the most complete list of
compatible intelligent SLC loop devices is provided in the SLC Wiring Manual; for conventional
non-addressable equipment see the Device Compatibility Document. Other control panels and their
equipment can also be connected in a network, via Noti•Fire•Net version 5.0 or High-Speed
Noti•Fire•Net; refer to the Noti•Fire•Net Version 5.0 Installation Manual or the High-Speed
Noti•Fire•Net Installation Manual for details. Some products are documented in a separate manual;
see Section 1.2 "Related Documents".
Notifier Compatible Equipment
ACM-24AT
ACM-48A
ACM-8RA
ACM-ZM
AEM-24AT
AEM-48A
AEM-ZM
ARM
LCD2-80
LDM-32
LDM-E32
LDM-R32
SCE-8A
SCS-8A
SCS-8LA
SGD
HS-NCM-MF
HS-NCM-MFSF
HS-NCM-SF
HS-NCM-W
HS-NCM-WMF
HS-NCM-WSF
NCA-2NZ
NCM-F
NCM-W
RPT-W
RPT-WF
AFP-3030 Installation Manual — P/N DOC-01-037:B 25/08/2016
Annunciators
Annunciator (Control)
Annunciator (Control)
8-way Relay Output Annunciator
Zone Mimic Annunciator
Annunciator (expander)
Annunciator (expander)
Zone Mimic Annunciator Expansion
Agent Release Module Kit
LCD Annunciator Kit
Lamp Driver Kit
Lamp Driver Expander Kit
Lamp Driver Relay Kit
Smoke Control Annunciator
(Expander)
Smoke Control Annunciator (Control)
Smoke Control Annunciator (Control)
Fire Brigade Alarm Signal Generating
Device
Network Control Modules
Network Control Module - Multi-mode
optical fibre
Network Control Module - Multi-mode/
Single-mode optical fibre
Network Control Module - Single-mode
optical fibre
Network Control Module - Wire
Network Control Module - Wire/Multi-
mode optical fibre
Network Control Module - Wire/ Single-
mode optical fibre
Network Control Annunciator
Network Control Module - Fibre
Network Control Module - Wire
NFN Wire-to-Wire Repeater
NFN Wire-to-MMOF repeater
Gateways
BACNET-GW-3 Bacnet gateway
DVC Digital Voice Command
MODBUS-GW Modbus-GW
NWS-3 NOTI-FIRE-NET WebServer
NFN-GW-AU-EM-3 NFN gateway (Embedded)
OnyxWorks OnyxWorks Workstation with and
without PC gateway
VESDA-HLI-GW VESDA-Net gateway
Detector/Sounder Base
AIBS32 Intelligent Base Sounder with
integrated isolator
B501 Addressable Detector Base
B524IEFT Short Circuit Isolator Base
NFX-BF-IVR Addressable Strobe Base (NFX
Series)
NFX-BS-IV Addressable Sounder Base (NFX
Series)
NFXI-BS-IV Addressable Sounder Base (NFX
Series)
NFX-BSF-IVR Addressable Sounder/Strobe Base
(NFX Series)
NFX-WF-RR Addressable Strobe (NFX Series)
NFX-WSF-RR Addressable Sounder/Strobe (NFX
Series)
NFX-WS-R Addressable Sounder (NFX Series)
System Overview
8