Setting For Battery Before Starting - Sanyo MPR-1411 Instruction Manual

OPTIONAL COMPONENTS

Setting for battery before starting

Always perform the setting shown below after the installation of battery for power failure alarm, an
optional component (MPR-48B).
The chamber temperature and "E09" is displayed on the temperature display alternately if the battery
switch is turned on without following procedure.
Turn off the battery switch, perform the following setting, and turn on the battery switch again if "E09" is
displayed on the temperature display.
Description of operation
1
Press numerical value shift key for
2
5 seconds.
Press numerical value shift key
3
twice.
4 Press digit shift key once.
Press numerical value shift key 4
5
times.
6 Press set key.
Press numerical value shift key and
7
scroll the figure to 1.
8 Press set key.
37
Key operated
The current chamber temperature is
-----
displayed.
F00 is displayed and the first digit
blinks.
The display is changed to F02 from
F00.
The second digit blinks.
The display is changed to F42 from
F02.
The current setting (000) is displayed
SET
and the first digit blinks.
The display is changed to 001 from
000.
The setting is memorized and
SET the current chamber temperature is
displayed.
- 75 -
Indication after operation