Sanyo MPR-1411 Instruction Manual page 35

OPTIONAL COMPONENTS
3. Remove the black rubber caps (inside and outside)
on the access port located at the top corner of the unit
and take the insulation out of the access port.
4. Pass the recorder sensor into the chamber through
the access port. (Fig. 3)
5. An attached binder (two pcs) is used for the fan
cover of the top of the chamber as the Fig. 4, and a
temperature sensor is fixed.
4. Route the capillary on the top of the chamber and fix
it with the provided clip and screw. (Fig. 5)
5. Make a cut on the rubber caps so that the capillary
can pass the caps and place them back on the access
port (inside and outside). (Fig. 6)
9. Bind the lead wire on the right upper side of the unit
with the provided band.
10. Remove the connector cap located on the right side
and then connect the recorder power. (Fig. 7)
11. Attach the recorder on the front cover with a screw.
(Fig. 8)
Space for temperature recorder
Connector for recorder power
- 72 -
Temperature
recorder sensor
Binder
Rubber cap
Screw
Fig. 7
Fig. 3
Fig. 4
Clip
Capillary
Fig. 5
Capillary
Fig. 6
Shaft
Fig. 8
Channel
34