Stryker Speed-Sheet 6010 Operation Manual

Operation Guide
ALTERNATIVE USE: TRANSFERRING PATIENT ONTO COT
1. Remove one Speed-Sheet from the dispenser.
2. Verify that the Speed-Sheet has not reached its expiration date.
3. Unfold Speed-Sheet.
4. Gently tilt the patient onto their side.
5. Center Speed-Sheet under the patient and put a linen sheet on top of Speed-Sheet.
6. Lower the patient onto the linen sheet.
7. See Transferring Patient Off the Cot instructions to transfer the patient onto the cot.
Note: A separate Speed-Sheet may be prepared on the cot mattress for later use
when transferring the patient off the cot. That Speed-Sheet should be tucked
underneath the Speed-Sheet that was placed under the patient.

Safety Precautions

WARNING
• Do not place Speed-Sheet under patients that are not being transported.
• Remove Speed-Sheet from under the patient if it is activated before the cot reaches
the receiving surface.
• Do not use Speed-Sheet to transfer patients with suspected spinal injuries.
• Do not attempt to transfer patient loads greater than what the operators can safely
manage. Evaluate the load and use additional assistance if necessary.
• Do not reuse an activated Speed-Sheet; it is not stable for patient transport.
• Inspect Speed-Sheet for obvious damage (tears, abrasions, or punctures) before
placing it back on the cot mattress to make sure that it was not activated or
damaged.
• Do not use a Speed-Sheet if any obvious damage is observed upon inspection.
• Failure to properly clean or dispose of a contaminated Speed-Sheet increases the
risk of exposure to bloodborne pathogens.
Note: Speed-Sheet is made with latex-free materials.
Cleaning
CLEANING SPEED-SHEET (IF NOT ACTIVATED)
If Speed-Sheet was not activated for a patient transfer, it can be manually cleaned (up
to 10 times) and placed back on the cot mattress for the next response. To clean, apply
one of the suggested cleaners by spray or pre-soaked wipes and allow the cleaner
to dry. Inspect the cleaned Speed-Sheet for obvious damage (tears, abrasions, or
punctures) before placing it back on the cot mattress to make sure that it was not
activated or damaged.
Suggested cleaners for Speed-Sheet include:
• Quaternary Cleaners (active ingredient - ammonium chloride)
• Phenolic Cleaners (active ingredient - o-phenylphenol)
• Chlorinated Bleach Solution (5.25% - less than 1 part bleach to 100 parts water)
Note: Use these cleaners in the concentrations recommended by their manufacturer.
Do not use Virex® TB germicidal or alcohol-based products on Speed-Sheet.
Warranty
Stryker EMS warrants to the original purchaser that the Stryker Speed-Sheet should be free from manufacturing
non-conformances that affect product performance and customer satisfaction for a period of one (1) year after
date of delivery. Stryker's obligation under this warranty is expressly limited to supplying replacement parts.
STRYKER MAKES NO OTHER WARRANTY OR REPRESENTATION EITHER EXPRESSED OR IMPLIED,
EXCEPT AS SET FORTH HEREIN. THERE IS NO WARRANTY OF MERCHANTABILITY AND THERE ARE NO
WARRANTIES OF FITNESS FOR ANY PARTICULAR PURPOSE. IN NO EVENT SHALL STRYKER BE LIABLE
HEREUNDER FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING FROM OR IN ANY MANNER
RELATED TO SALES OR USE OF ANY SUCH EQUIPMENT.
RETURN POLICY
Speed-Sheet may be returned up to 60 days of receipt under the following conditions:
Prior to 30 Days
• Product must be unused, undamaged, and in the original packaging.
• Customer will receive a full refund.
Prior to 60 Days
• Product must be unused, undamaged, and in the original packaging.
• Customer is responsible for a 15% restocking fee.
RETURN AUTHORIZATION
Stryker customer service department must approve any merchandise return and will provide an authorization
number to be printed on any returned merchandise. Stryker reserves the right to charge shipping and restocking
fees on returned items. SPECIAL, MODIFIED, OR DISCONTINUED ITEMS NOT SUBJECT TO RETURN.
DAMAGED MERCHANDISE
ICC Regulations require that claims for damaged merchandise must be made with the carrier within fifteen
(15) days of receipt of merchandise. DO NOT ACCEPT DAMAGED SHIPMENTS UNLESS SUCH DAMAGE IS
NOTED ON THE DELIVERY RECEIPT AT THE TIME OF RECEIPT. Upon prompt notification, Stryker will file a
freight claim with the appropriate carrier for damages incurred. Claim will be limited in amount to the actual
replacement cost. In the event that this information is not received by Stryker within the fifteen (15) day period
following the delivery of the merchandise, or the damage was not noted on the delivery receipt at the time
of receipt, the customer will be responsible for payment of the original invoice in full. Claims for any short
shipment must be made within thirty (30) days of invoice.
INTERNATIONAL WARRANTY CLAUSE
This warranty reflects U.S. domestic policy. Warranty outside the U.S. may vary by country. Please contact your
local Stryker Medical representative for additional information.
PATENT INFORMATION
Stryker Speed-Sheet is covered by one or more of the following patents:
United States 7,650,654
The yellow and black color scheme is a proprietary trademark of Stryker Corporation.
Manufactured For
Stryker Medical
3800 E. Centre Ave.
Portage, MI 49002
U.S.A.
EC REP
European Representative
Stryker France
ZAC Satolas Green Pusignan
Av. De Satolas Green
69881 MEYZIEU Cedex
France
2010/10 6010-009-001 REV D
For technical assistance:
USA: 1-800-327-0770
www.stryker.com 2010/10
Speed-Sheet™
Model 6010
Operations Manual
6010-009-001 REV D www.stryker.com