Cisco NCS 4000 Series Hardware Installation Manual page 75

Installing Power Components
Figure 54: Connecting Power Cables to Terminal Blocks
1
Connecting Power to the Chassis
Use one of the following procedures to connect power to your chassis:
Connecting Power to an AC-Powered Chassis
Follow these steps to connect the AC power cords to the chassis.
Note Connect each AC power supply to a dedicated power source (branch circuit). Each AC input power supply
operates at a nominal input level of 200 to 240 VAC.
Terminal Blocks
Hardware Installation Guide for the Cisco NCS 4000 Series
Connecting Power to the Chassis
73