Installing The Projector In Proper Position; Air Circulation; Installing The Projector In Proper Directions; Moving The Projector - Sanyo PLC-XU300 Owner's Manual

Safety Instructions

Air Circulation

Openings in the cabinet are provided for ventilation. To
ensure reliable operation of the product and to protect it
from overheating, these openings must not be blocked
or covered.
CAUTION
Hot air is exhausted from the exhaust vent. When using
or installing the projector, the following precautions
should be taken.
– Do not put any flammable object or spray can near the
projector, hot air is exhausted from the air vents.
– Keep the exhaust vent at least 3' (1 m) away from any
objects.
– D o not touch a peripheral part of the exhaust vent,
especially screws and metallic parts. These areas will
become hot while the projector is being used.
– D o not put anything on the cabinet. Objects put on the
cabinet will not only get damaged but also may cause
fire hazard by heat.
Cooling fans are provided to cool down the projector.
The fans' running speed is changed according to the
temperature inside the projector.
Exhaust Vent
(Hot air exhaust)
Exhaust Vent
(Hot air exhaust)
6
Air intake Vent
Air Intake Vent
Air Intake Vent

Installing the Projector in Proper Position

Install the projector properly. Improper Installation may
reduce the lamp life and cause a fire hazard.
Do not tilt the projector more than 20
20°
degrees from side to side.
20°
Do not tilt the projector more than 30
30°
degrees from above and below.
30°
Do not point the projector up to project an
image.
Do not point the projector down to project
an image.
Do not put the projector on either side to
project an image.

Moving the Projector

When moving the projector, replace the lens cap and
retract adjustable feet to prevent damage to the lens and
cabinet.
When the projector is not in use for an extended period,
put it into a suitable case with the lens side up.
C AUTION IN CARRyING OR TRANSPORTING
THE PROjECTOR
– Do not drop or bump the projector, otherwise damages
or malfunctions may result.
– W hen carrying the projector, use a suitable carrying case.
– D o not transport the projector by courier or any other
transport service in an unsuitable transport case. This
may cause damage to the projector. For information
about transporting the projector by courier or any other
transport service, consult your dealer.
– D o not put the projector in a case before the projector is
cooled enough.